Ive had an interest in this fence for awhile, because my OEM Laguna LT20 fence is a very stubby cast iron fence. The OEM fence is fine, ive made a lot of furniture with it, but it doesnt adjust easily in either direction. The fence face is slightly out of 90° to the table/blade, and ive just dealt with it. Aside from grinding the cast iron foot to the base of the fence, i dont think i could adjust the fence to match the blade. Next, i wish the fence was longer to register workpieces to. The current fence is maybe 10-12" long, and barely extends past the back of the blade. I have no interest in the drift adjustment of the fence. My bandsaw blade doesnt drift.

Is it a worthwhile pick up? There is a used one on the route of my road trip tomorrow that i could pick up for $200. I figure for the price it would be a good addition for the taller and longer fence. I might use the fine adjustment every once in awhile as well.