With the end of my term as faculty senate president (and the reprieve from endless meetings)and opting out of teaching summer classes, I decided to upgrade my old Kreg K2000 pocket hole jig(which I do like) with a new K5. I guess I didn't get the the stop collar completely tightened down on the bit. The pocket holes keep getting deeper, until...

the Holy K5
IMG_0835.jpgIMG_0836.jpg
Note the extra hole.



The project did come out ok though. Just some shop storage. Still trying to figure out the arrangements of stuff on the shelves. I did figure out a cheap source for decent casters. Northern tools have their moving dollies on sale pretty frequency for about $7.49 (or was is $7.99?). They also often have additional off coupons. The dollies are 1000 lb, so the casters are 250 lb each.

IMG_0837 cropped.jpgIMG_0839 rotated cropped.jpg


Nice to get back into the shop


John