IMG_4598 (640x480).jpg
Legs were ripped down from a scrap 2 x 10, and are 25" long, tapered on two inside faces.
right side.jpg
Top is a glue up, took a 4' long 1 x 10, cut into two 24" long pieces, then book matched
left side.jpg
If you turn the table in the light..grain changes how it shines..
insides.jpg
Underneath, there are corner blocks. Aprons join the legs via Mortise and Tenon joints...this is the bottom of the panel, because it was having too much tearout.
One coat of Golden Oak stain, then one coat of Poly Gloss Varnish.
Top is 3/4" x 18" x 24" Router was used to make a cove detail around the edges, after the corners were cut round...

Simple, little table...