Hi all,

I've done quite a few searches and looked on youtube but am still having issues with my a3-31 and euro guard.

I thought when jointing that it was best to apply pressure on the outfeed table and basic forward motion from the rear.

With the euroguard the board passes below the guard, which means that the forward push block is removed temporarily (and the pressure is too) to move to the outfeed table as the board passes over the cutter head.

This results in some weird snipe, or bumps/ridges the width of the board near.

I have wasted plenty of material trying to figure out what I'm doing wrong. It's time to ask for help.

Anyone have a good video and or set of instructions that I can use to joint safely and avoid this situation?

Thank you.