-
Well, I guess I'm not done quite yet.
Very strongly believe in what I said.
There is about 4 possibles in link below, right now, all around $250.
And that's just today.. where you live.. new stuff all the time.
And also, you got all those used machinery dealers concentrated in a few next to each other warehouses in Hopkins.
Just SW of Excelsior Blvd. ( ? Cty. 3?) and as I recall ? 11th Av.
I almost bought a Delta saw 12/14 there years ago.
Back to the Craigslist, most or all possibles at top of page.
You are fortunate to live in/ near a highly populated are.
Many possibilities.
I live in the deep TX woods now, lucky If I have 5 new entries/ week in Craigslist tool category within a 100 miles.
Then it's almost always like a beat up Black & Decker Circ Saw for $20.
So live in TX 12 yrs now, escaped the Snow, but now in the heat and humidity.
No panaceia overall, just different extremes.
Brought up S MPLS, then Minnetonka/ Mound, even a cheap lot on the Lake for a few years.
Craigslist - Ya, one has a 3 phase, I saw that... relatively rare for this size machine.
A little 3/4 hp aftermarket motor is not much $ if the machine condition deserves it.
Again, whatever........... GO Jineez !!!! if you wish. Marc
https://minneapolis.craigslist.org/s...press&sort=rel
Last edited by Marc Jeske; 08-03-2017 at 8:31 PM.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules