I am turning a lot of small spindles lately. They are about 8-9 inches long, and about 1/4" diameter. I am getting a lot of chatter, especially on soft wood like Box Elder burl. I want to make a light duty spindle steady that will support them from the back side, to decrease the chatter. I looked at router bit guide bearings for the wheels, but most were between $35 and $60. Not worth it. I found some wheels for a sliding glass door that had a bearing, but they were not really designed for this kind of mileage and RPM, so I don't know if they will work. I also have to create a design that will hold the steady wheels off center, so they don't interfere with my banjo. I am using a Delta 46-460, and an LA 200 lathe, and want to build one for each. The only difference will be the spindle height. Has anyone ever made one, and do you have plans? It would be nice if I didn't have to reinvent the wheel (no pun intended). Thanks for the help.