I recently picked up a used pneumatic Foreman pocket hole machine. I have a question about the power of air drill motor. Even at 120+ PSI it still takes several seconds maybe even six or seven to complete a cycle. I can stall the air motor out I think rather easily. According to the instruction manual it is supposed to complete a cycle in one second.

Yes my air compressor is more than adequate, I have even hooked it up directly to the compressor through a high-volume 3/8 inch connector.

I am wondering if this is typical or if my air motor is weak?
If this is typical of the air motors does the electric version have more power? I have never used or seen one except the one I have.