Results 1 to 14 of 14

Thread: How would you produce this in a shop

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 03-06-2005, 4:47 PM #1
    Harry Thornton
    Harry Thornton is offline [OP] Member
    Join Date
    Mar 2005
    Posts
    76

    How would you produce this in a shop

    I want to make slate type turkey calls from wood such as walnut, cherry, etc. I am attaching a picture of the top and bottom as well as a cutaway profile. They are about 4" in diameter and about an inch thick. Would you use a lathe, drill press or what?
    Attached Images Attached Images
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. New shop gloat
    By Ian Barley in forum General Woodworking and Power Tools
    Replies: 18
    Last Post: 11-19-2004, 7:55 AM
  2. Time for a Shop Tour
    By Dick Parr in forum General Woodworking and Power Tools
    Replies: 30
    Last Post: 09-15-2004, 3:02 PM
  3. Well, since everybody else is working on their shop...PICS....
    By Terry Hatfield in forum General Woodworking and Power Tools
    Replies: 15
    Last Post: 07-19-2004, 12:14 AM
  4. Shop Tour (pics)
    By Fred Voorhees in forum General Woodworking and Power Tools
    Replies: 17
    Last Post: 03-14-2004, 11:33 AM
  5. A warm shop
    By Tom Sweeney in forum General Woodworking and Power Tools
    Replies: 17
    Last Post: 12-13-2003, 10:13 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules