So, I was looking at my saw and I have never understood why they don't make the surface of the table some sort of non slip surface. The biggest problem I have with my cuts being inaccurate is when the blade wants to pull the work piece into the fence. I don't really want to buy a 40 dollar clamp plus they can't always be used. Does anyone have a reason that it would be an issue to apply a 60 grit sandpaper to the entire surface of the table? The only downside I can see is that eventually it will wear off and then you have to get it all cleaned off but as little as I use my saw I would think I would get a long time out of the sandpaper. I am thinking about trying this on my Dewalt that I replaced with my new Milwaukee. Let me know if anyone sees any downsides to this.