Jig Grinding help Needed

[Jon Lanier]

Does anyone know where I can get the pattern for this Fingernail Jig so I can use it with my Wolverine System?

[Ken Fitzgerald]

Jon,

Check this link: http://www.turningtools.co.uk/widget.../grindjig.html

there's a pdf file about 1/2 down the page.

[Gordon Seto]

You may measure off from this pdf copy. It is to scale.

http://www.thompsonlathetools.com/im...Sharpening.pdf

[Ken Fitzgerald]

Jon,

Here's a slightly different one with step by step instructions.

http://www.aroundthewoods.com/sharpening03.html

[Don Carter]

What about this page?
http://ebenisteriepatton.50megs.com/...ool%20rest.pdf

Not sure if this is what you need. I use the one that Darrell Feltmate makes, it is a square block with a dowel and hole in it. It is at http://www.aroundthewoods.com/
Hope this helps.
All the best.

Don

[Jon Lanier]

What about this page?
http://ebenisteriepatton.50megs.com/...ool%20rest.pdf

Don

Thanks everyone!!! Don, I think that is the one I'm looking for... if that was going to show up, I thought I'd go with the "Around the Woods" design.

-Jon

[Leo Van Der Loo]

Yes Don that's the one,and here's the site address, though Jean did pas away several years ago, the site has been kept up.

There are several other good ideas in there,

http://www.atbq.qc.ca/jm2/woodturnjigs.htm