Anyone have some settins for cutting 3/32 (.093) thick rubber for a 75 watt Epilog EXT??? The settings in the book seems like a misprint...
Anyone have some settins for cutting 3/32 (.093) thick rubber for a 75 watt Epilog EXT??? The settings in the book seems like a misprint...
Epilog 75 Watt 36 EXT... Corel X3... PhotoGraV...
For my 45 Watt Helix
20sp/100pwr at 300dpi
30sp/100pwr at 400dpi
40sp/100pwr at 600dpi
20sp/100pwr/100Freq
It will not be much different for yours. I would suggest an increase and make yours 40 60 an 80 on your speeds and 30 speed on your vectoring.
Epilog 45w Helix X3/X5 Corel Microflame Generator (flame polisher) Heat Bender
What frequency???
Epilog 75 Watt 36 EXT... Corel X3... PhotoGraV...
Still 100 as above
Epilog 45w Helix X3/X5 Corel Microflame Generator (flame polisher) Heat Bender
For JMP rubber our 45 watt Mini takes 13sp/100pwr/300dpi and cuts at 7sp/1--pwr/100freq.
Longtai 460 with 100 watt EFR, mostly for fun. More power is good!! And a shop with enough wood working tools to make a lot of sawdust. Ex-owner of Shenhui 460-80 and engraving business with 45 watt Epilog Mini18.
The rubber was an 80 on the durometer...
5% speed, 100% Power, 500 Frequencey on a 75 WATT...
Got the job done thanks to the Board...
Thanks So MUCH!!!
Mark
Epilog 75 Watt 36 EXT... Corel X3... PhotoGraV...