Hello everyone, I have a pinnacle M series laser and am currently trying to cut puzzles out of balsa wood. It cuts great, and the pieces look good, but the problem is that it is cutting the lines that connect two interior pieces of the puzzle twice. So it is leaving a larger scorch mark on those pieces. If I cut each individual piece seperate, they look and match well. But there has to be a way to make one cut, so that the pieces touching doesnt get hit twice. I have tried combining them, but did not help. I am using Corel X3, and also Flexi 8 software. Both will do the same thing, even after combining or welding. Didnt know if I had to cut each piece seperate, but it would be quicker and simpler to leave the puzzle together. Any advice would be appreciated. Thanks!!