When did you join SMC?
According to this webbsite I joined in June of 2004, though I know that for quite a long time all I did was to lurk as my turning skills were ... well lets just say that I had none.
How did you find out about this site?
Probably found the site by googling something to do with turning.
What do you enjoy the most about SMC?
I think that without finding this site it would have taken me considerably longer to learn some of the asthetics of turning, with the help of others I've learned what is right or wrong about a piece, and what perhaps I should do differently to improve my work, everyone here seems to show a generous interest in helping others.
What is the make, model and year of your lathe?
I turn on a General 260-20vs I purchased the lathe used back in 2006 ( at the time I was told it was 2 yrs old so that would make it a 2004 model I believe ) but really did not start to use it till sometime in 2007 as I didn't have it set up till then
What is your lathe's capacity?
My lathe has an inboard capacity of 20" but in 2010 I purchased the outboard attachment which gives me a capacity of 28" but I have yet to use this feature.