Hello,
Please could someone point me in the right direction of the article showing the picture of the indexing fixture for making curved inlays for pens.
Many thanks
Nigel
Hello,
Please could someone point me in the right direction of the article showing the picture of the indexing fixture for making curved inlays for pens.
Many thanks
Nigel
Nigel Morgan, Epilog Helix 45W, Techno Isel 3024, Corel 12, ArtCam
If I understand what you are looking for
http://www.distinctiveturnings.com/t...gPenBlanks.pdf
The article by Ron Sardo shows how it is done, but it is not done with a jig.
If that is not what you are talking about please show a picture and someone can tell you how it is done.
Mike Vickery
Nigel
There is a good article in the current issue of Woodturning Design magazine that might help. Basically the author stacks and bandsaws two pen blanks. Then mis-matches the pieces from each blank to combine the woods.
Frank
'Sawdust is better than Prozac'
Try this link;
http://www.sawmillcreek.org/showthre...=stars+stripes
.
Thanks for the help
Cheers
Nigel
Nigel Morgan, Epilog Helix 45W, Techno Isel 3024, Corel 12, ArtCam
Try the link again.
.