Results 1 to 1 of 1

Thread: Bowl Design

  1. #1

    Bowl Design

    I like to use computer drawing programs to make designs for segmented turning. I will print my design on 1/4" graph paper. from that I can take actual dimensions. The outline gives width & length. I can also change the curves, If I allow enough wood. Maybe this design will give you ideas also. I will also list my web site which is devoted to segmented turning. GTH
    Last edited by George Troy Hurlburt; 02-15-2006 at 9:54 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts