Drill cadie/holder

[Greg Wandless]

I am looking for ideas for a cordless/corded drill cadie/holder that I can mount on a wall.

I know I have seen them in magazines but I just can't remember which one and I have searched a couple of the forums and online and have not come up with anything. Anybody know of any plans/ideas?

Thanks,
Greg

[Ken Werner]

I just use a couple of curved hooks in my pegboard.
Ken

[Jerry White]

Greg,

I'm unable to post a link here, but you can see a couple of good ideas if you go over to the Woodworking Power Tools forum on Woodnet and do a search for "Looking for a cordless drill holder idea".

[Brian Dormer]

Greg -

Cut a 10" piece of 4" PVC drain pipe (check in the plumbing section at HD or Lowes - they sell 4 ft pieces) - cut a 1 3/8 slot in the pipe lengthwise (you can cut all the way down if you want - or stop 1/2 way. You can hang this vertical or horizontal (with a little "downhill" slope to keep the drill from slipping out).

Doesn't get much easier or cheaper than that.

bd

[Christian Aufreiter]

Here is a pic of "my" design.

Hope this helps,

Christian

[glenn bradley]

Maybe this one from ShopNotes: