I am not a turner, yet, but I did take a lesson from Bill Grumbine which I really enjoyed.
I always thought the old Pond should have had a separate board for turners. My reason was there were so many turning questions and posts, if they had their own board, it would have been bigger than the Neanders.
I am not trying to divide the community into endless factions, merely give the turners a place to call home. Then, when I finally take my Jet Mini lathe out of the box, I'll know where to go for information.
I would appreciate any thoughts on this idea from Keith and the "regular" turners that lurk here.
Suggestions for a name would be good too...
Maybe, "Mill turnings"?