Are there any compressors that will provide an honest 7.0 delivered cfm at 90 psi, AND still run on 110 volt power. That would run a moderate selection of HVLP guns down the road but still be convenient (if overkill) for running a nailer for a remodeling project coming up.
I could just get a small pancake for a nailer, and wait until needed for a larger compressor tailored for spraying.
Or I could go ahead and get the last compressor I'll ever need (in the range of 14 cfm @ 90 psi.) I'm a bit inclined this way, If I have to put up with the hassle of using 220 power for the remodel project then I might as well get the most out of the "tool acquisition project". (220 only available in basement, when I run the new circuit from the box--project is second floor.)