[OP]
Member
I've got to do a 2 day demo for my Guild in a couple months, so I've been busy getting my mini lathe rigged up for it. I wanted to be able to set up and break down the rig easily. I welded a frame for the vacuum pump that rides on the center stretcher of the lathe stand. The hose from the filter to the gauge assembly has a 1/4" quick connector on one end and the gauge stalk connects to the lathe bed with 2 screws. I think it's ready!
Contributor
That is a great looking setup Travis. Nice job. Very clean and out of the way of your turning.
Bernie
Never put off until tomorrow what you can do the day after tomorrow.
To succeed in life, you need three things: a wishbone, a backbone and a funnybone.
Member
Very impressive! Very efficient!
Member
Just a show off is all I got to say....Nice work Travis!
Big Mike
I have done so much with so little for so long I am now qualified to do anything with nothing......
P.S. If you are interested in plans for any project that I post, just put some money in an envelope and mail it to me and I will keep it.
Member
Nice set up Travis!
That mini is going to be even more fun to play with now!
Have Chainsaw- Will Travel
Moderator
Wow Travis....that looks Good!!!!!! Real good in fact. Congrats bud on a job well done. Very clean setup without a lot of clutter.
Thanks & Happy Wood Chips,
Dennis -
Get the Benefits of Being an SMC Contributor..!
....DEBT is nothing more than yesterday's spending taken from tomorrow's income.
Member
Smooth execution Travis.
Access to controls looks to be very convenient, and it’s durned good looking too!
Bet this will be a fine demo for your Guild.
Frank
Posting Permissions
Reply With Quote