I have a ULS Versalaser VL300 50 watts. I've had cracked lenses (quickly replaced by ULS), a wire leading to the lens carriage pop out (I repaired myself) and the height adjustment getting stuck (still does now and then).
And now this...
when I turn the power on, the lens carriage moves rapidly for about 10seconds from left to right (1/4" to 1/8") from side to side. And then will stop. Clicking Print will make it continue to do the same indefinitely which I had to power off to stop. The shaking is so much that it would make the lens come loose.
I was told by my local ULS dealer here in the philippines that they experienced similar problems and reinstalled the software and cured it. After uninstalling and reinstalling the drivers and the software, the same thing.
I know there are ULS dealers here. Would you or anyone else know what the problem is or what I should do???
In the meantime, my 25 watt mercury just arrived and is waiting to be installed. I am hoping I wont have as much problems with the mercury as I am having with my ULS. Everyone says ULS lasers are one of the best. Right now with my experience, I'm not sure.
harry