Shaper Workstation Setup Question

[James Jayko]

I've used the grid for the Shaper Origin and the Workstation as suggested up to this point. I'm going to make a sign that is 36" long, so I can't grid it the traditional way (IE two reference points on the bottom, one on the end as the piece will be hanging off both ends). How do I orient the machine to where it is when this is the case?

[Alex Kapl]

Why can't you grid? just grid of the material. 36" might be too much for workstation as you might not have enough dominoes. i would just skip the workstation for this

[Michael Burnside]

I would use the domino tape and create a workspace directly on the workpiece or a surface in front of the material that is the same height. Then just reference off the actual material. Easy peazy.

[Alex Kapl]

I would use the domino tape and create a workspace directly on the workpiece or a surface in front of the material that is the same height. Then just reference off the actual material. Easy peazy.

Exatly this