Nice work, Tom!
I think Jerry is right, the thread pitch is likely finer than a normal coarse or fine hex nut.
Contributor
Nice work, Tom!
I think Jerry is right, the thread pitch is likely finer than a normal coarse or fine hex nut.
Bumbling forward into the unknown.
Contributor
Glad to see you got the nut off, and the spindle cartridge out.
Picture of the nut is a little blurry, is that a nyloc nut or is there some type of thread retainer?
Confidence: The feeling you experience before you fully understand the situation
[OP]
Contributor
Jerry, It is a nyloc nut.
For the rest of you SCM shaper owners you may want to check for a grease cup. Fill cup with grease and tighten up now and then I guess. Note hole at 12 o clock position.100_2650.jpg Cup is in cabinet to left rear side.
Posting Permissions
Reply With Quote