Cutting 45's on an Incra for a 46" square frame

[Robert Hayward]

I struggled with the same condition until I invested in a shooting board and shooting plane. As with most everything in the woodworking hobby it did not end there however. The shooting plane iron must be kept very keenly sharp requiring sharpening equipment that a mostly power tool guy does not own.

[Richard Coers]

5" wide is going to show some kind of crack over the years. That flat sawn wood is going to shrink next winter and this will be the result. Quarter sawn is a much better choice.
Screenshot 2024-04-28 at 2.33.03 PM.jpg

[Steve Jenkins]

When cutting miters it easy for the stock to slip slightly. Put a piece of psa sandpaper either flat on the surface of the sled or on the sled fence. 220 git is fine.

[Brian Runau]

When cutting miters it easy for the stock to slip slightly. Put a piece of psa sandpaper either flat on the surface of the sled or on the sled fence. 220 git is fine.

Steve, I'm using a sled with a hold down, still slipping you think? thanks brian

[Brian Runau]

5" wide is going to show some kind of crack over the years. That flat sawn wood is going to shrink next winter and this will be the result. Quarter sawn is a much better choice.
Screenshot 2024-04-28 at 2.33.03 PM.jpg

Richard, it's for an outdoor table top using cypress, miter corners would look better, but might be a bad choice. Butt joint is probably a better choice. Thanks. Brian

[John TenEyck]

Richard, it's for an outdoor table top using cypress, miter corners would look better, but might be a bad choice. Butt joint is probably a better choice. Thanks. Brian

I suggest a two piece approach. Use a butt joint with the thinner interior section. Then wrap it with the thicker outer molded piece using 45's. Put a rabbett on the outer piece so it overlaps the thinner pieces.




John