Stanley Yankee No. 130A spiral “push” screw driver
One slot-screwdriver bit is included.
$25.00 plus shipping.
Zelle or Venmo preferred, but will accept PayPal or personal check (will ship after check clears).
This Yankee No. 130A spiral “push” screw driver was marketed by Stanley after it acquired North Bros. Manufacturing (the original Yankee manufacturer) in the 1940's. The Yankees came in 3 sizes. The 130A was the medium size, about 17" when fully extended (without a bit) and about 12" when not extended, and the chuck takes a bit shank size of 9/32" diameter. This is the deluxe model that has an internal spring in the tube that pushes the bit outward. This feature was intended to help keep the bit locked in the screw and allows for possible one-handed use. One push of the handle causes the bit to rotate 2 ˝ times. A clipping from a 1949 Stanley tools catalog describing this model Yankee Driver is included in the photos. Also included is a photo of the instructions from a 30A box (same model but without the internal spring) – sorry, box not included.
This particular Yankee was mechanically sound when obtained, but the handle needed refinishing. After sanding, several coats of shellac were applied to the handle followed by a coat of Minwax tung oil for durability. The handle now feels good and shows some nice patina. This tool has been cleaned and lubricated and works well.
Note: A hex adapter bit can be purchased for the Yankee from Lee Valley Tools that allows this tool to be used with any standard hex driver bits (be sure to look for the 9/32" adapter size).
Reply With Quote
