I have a new table saw and I am setting up my Incra miter express sled. Slots are a little different from the blade, but room for cut offs no problem. Blade, using a calibration disc for set up and a digital dial indicator, is .0005 to parallel.
I would normally use my large square in the open miter slot to square the Incra fence, but this seems cumbersome with the height of the sled base. I can put my digital dial indicator in the open slot and use it to check square, but I can't come up with anything to put against the fence with a wide enough surface facing the open slot to run the dial indicator tip against.
Appreciate any suggestions.
Thanks.
Brian