[OP]
Contributor
I have a Gravograph IS200 and I'm engraving multiple medals. The spindle is not lifting high enough between the jobs and tip is dragging into vice between engraving. I cant work out how to get it to raise higher between medals.
I have sorted .. was trying to do on the machine instead of in machining settings.. Dhhhhh!
Last edited by Julie Ramsay; 12-13-2023 at 5:57 PM. Reason: Sorted problem
CX1200 Laser 100 Watt
Maxpro
Gravograph 400
Gravograph 200
TXL
Sublimation
Contributor
Have you tried to raise the cutter at the screw fitting (). Sounds like the down travel is set high.
.
Mark
In the Great Northwest!
Trotec Speedy C25, Newing-Hall 350 (AMC I & HPGL), NH-CG-30 (Carbide Cutter Sharpener)
Sawgrass 400 Gel Ink Printer, CS5, 5/9/x6 CorelDraw
Moderator
Julie
there are a couple of things on YouTube on this. You can try to do it through the tool and spindle but I always set mine with the software.
Mike Null
St. Louis Laser, Inc.
Trotec Speedy 300, 80 watt
Gravograph IS400
Woodworking shop CLTT and Laser Sublimation
Dye Sublimation
CorelDraw X5, X7
Reply With Quote
