I have had a PM26 Shaper over 30 years and have less than hours use on it, Grizzly power feeder new in box will have its 30th birthday in a few months.
I really want to get a handle on using it properly, don't feel comfortable with the factory fence setup. I had an AMT shaper kit bought back in the early 80's and used it with home-built fences. Then got the PM26 and could not get the fence to work for me. Probably will put it on a mobile base to drag it out of its corner where it hides. Hoping to find time for this after Christmas, so asking for pictures of home built fences now to think on all this.
Any tips, good books to read, magazine articles, etc. would be appreciated. I really don't have any desire to run router bits with it or to own a router table. 1/2 and 3/4 arbors. some basic 1/2 steel bits and 3/4 locking miter cutter are what I have.
Thank you
Ron