How do I make the 40° angle cuts on this board?
The boards will be milled to 1 1/4" thick.
After I trim the angles shown on the edges I will then mill a cove on one face.
Screenshot 2023-09-02 at 8.31.03 AM.jpg
I can rip the 50° angle the normal way - tilt the blade to 50°, clamp on a sacrificial fence, tune in the fence position and rip the boards.
The 40° rip is what has me stumped right now.
My saw is a right-tilt Unisaw.
What do I do?
thanks, Mark