Used these machines for many and varied operations from producing electronic circuit boards to small ply boxes together with engraving. In total we four machines running, alas now due to incompetent department leadership I believe these now live on top of each other in a pile in the corner - what a sad waste.
I have obtained a EGX 300 through a contact at another school and hope to make use of it in my retirement. I did find a drive belt to get it running (apparently an O ring seal from a oil filter.) after trying several sizes.
Contacted UK supplier to determine the actual specification of the belt. They are unable/declined to do so, after charging £38.64 for an O ring is a bit like printing money.
Getting to the point does anybody know the diameter and cross-section diameter and perhaps the material of the belts used on an EGX 300?
Reply With Quote
