RDWorks problem

[Roger Lueck]

RDWorks Version V8 8.01.18
Windows 10
CorelDraw X7

Hello,

I had finished an engraving project and loaded another file into RDWorks from CorelDraw.

I changed only the speed and power settings in RDWorks in preparation for the next project.

I used the mouse pointer to “press” the start button to send the file to the laser.

The laser beeped 3 times and nothing happened.

I assumed the 3 beeps were indicating something was wrong, however, nothing appeared on the laser keypad screen or on the computer screen in RDWorks.

I checked the USB cable, it appeared to be plugged in and it had carried a signal to the computer that prompted the 3 beeps.

I re-started the laser, it found home and then proceeded to the last point of origin I had used. It appeared to be ready to receive a file to engrave.

I also re-installed the copy of the “Vendor Settings” with idea that I had changed a setting accidentally.

Has anyone experienced this problem?

Does anyone have a possible solution to this problem?


Thank You,
Roger

[Roger Lueck]

Problem resolved. File was corrupted.