On my new bench, I have a Benchcrafted leg vise on the left side and a Veritas sliding tail vise on the right. The bench is relatively low at only 33-3/4 off the ground. This was on purpose to keep it lower than my table saw, but also to put it in a comfortable height for me for planing. I have another bench that is 37" off the ground that I thought about installing the Veritas twin screw vise on the front of however, I'm also looking at just adding a Moxon Vise or Dovetail vise instead so that the front of that bench stays open and unencumbered.
In looking at the options out there, I'm sort of narrowed down to 3 so far. The Lie Nielsen Dovetail vise, the Benchcrafted Moxon vise or the Woodriver Cozmanized kit. I don't mind spending for quality if it's warranted and I like that both Lie Nielsen and Benchcrafted offer prebuilt versions so I can put them straight to work. However, I'm guessing the Benchcrafted prebuilt is built to order where the Lie Nielsen version would ship right away. I like the spring feature on the Rob Cosman version but don't feel that's a huge deal quite honestly. I like the fact that the Lie Nielsen version has 6" capacity versus the 4" capacity on the other two.
I'd like to stick to one of these 3 kits/prebuilts or something of similar quality. Anyone have one of these 3 Moxon/Dovetail setups that can offer input on them?
Thank you.