FS: Pair of Microjig pushblocks NEW!

[Richard Thompson]

Two Microjig pushblocks for safety on all woodworking machinery--jointer, router table, table saw, bandsaw. The pushblocks have proprietary green GRR-RIP for extreme hold and retracting heels to hook the tail-end of your board or automatically lay flat. The handle exerts directional pressure against the fence. These are the best pushblocks I've ever used—liked them so much I ended up with 2 sets

$45 shipped

[richard newman]

Message sent

[Eric Arnsdorff]

Hi Richard,
I'll take the pushblocks if they're still available!
I've sent a PM.
Eric

[Tom M King]

I use those and like them a lot. The only thing I wish they had was some built in magnets to stick them to the jointer because finding somewhere to put them is the only problem.

[Richard Thompson]

The push blocks are sold.
Ditto on Tom's post. I ended up making a shallow tray to fit both longways then attached the side to the jointer bed with rare earth magnets.