Base is out of the clamps...glue joints cleaned up...base has been squared up enough to do a dry fit..
Base & Door, test fit .JPG
well, it is able to support the case...without falling over..method of attachment...
Base & Door, attachment points .JPG
3 counter sunk 3/4" screws..and a bit of glue...I also off-set the case to the stand..
Base & Door, Offset, front .JPG
To be under the doors, too..
Set this aside for now..and start on the doors..rebates were in need of a bit of leveling..
Base & Door, clean a rebate .JPG
Both doors. had a few high spots to level out...
Then plane the ends until they are flush with the top of the case...and sit on the offset equally across the front..was a bit of plane, test fit, plane a bit more, test fit again..etc..
needed to get this done, BEFORE I start to lay out for hinges...
Stay tuned..