New router table and Incra TS LS questions

[Greg Parrish]

I’m super excited to have another router setup finally. I picked up a sawstop in-line router table, a Woodpeckers Spinrite motor and have an Incra Mast-R-Lift coming next week. I mounted the table to the left of my blade based on my tool layout and it fits nicely there and seems super stable. I also discovered that I can get the motor cover open if ever needed by pulling the hinge pin out.

Now to the question, I am very intrigued by the Incra TS LS system to serve the table saw and router. I’ve figured out how the folding outfeed table can still be mounted, but I also have the floating overarm dust pickup and it is mounted about the center of the right end of the table. Has anyone modified this to still allow the Incra positioned to clear it?

919F11B7-BC43-4102-92CA-6D31928265DE.jpg

DD5F8C08-3BBE-416F-ABA9-5190702D5C48.jpg

And yes, I know it’s too clean. Can’t help myself for cleaning after each use since it’s a shared space for other family uses.