After I upgraded my software and firmware my images are off , not in center of work
Any ideas
Jobcontrol 11.4.4
After I upgraded my software and firmware my images are off , not in center of work
Any ideas
Jobcontrol 11.4.4
There is a setting to adjust offset for both axis.
Go to: options/service/service settings/offset
You will have to measure with micrometer and adjust one or both axis to best results.
Trotec Speedy 300 - 60w, with Quatro CSA-626 fume extraction
Xenetech 1625 x2,
New Hermes TX pantograph, CG4 cutter grinder
Brady Globalmark2 label printer,
Assortment of custom tooling , shears & punches, heat bender.
Software: Xenetech XOT, Corel X3, Bartender label software
Machine has to be running and connected to PC.
Once machine was connected, just pressed ctrl - alt - s
then select offset.
Make adjustments and
then click 'get present offsets' and apply.
Trotec Speedy 300 - 60w, with Quatro CSA-626 fume extraction
Xenetech 1625 x2,
New Hermes TX pantograph, CG4 cutter grinder
Brady Globalmark2 label printer,
Assortment of custom tooling , shears & punches, heat bender.
Software: Xenetech XOT, Corel X3, Bartender label software
Tried this and did not work ctrl -alt - s ,with laser running and connected
Thanks for you help , I am going to phone Trotec this morning