Good morning. Two questions
1. I actually cleaned out the dust bin on my router table and found this aluminum, I think bushing, inside the dust bin. No idea what it is or how it got there. I have a Kreg table, Kreg lift with a Bosch router. Lift seems to work fine, so if it is missing a part...
2. Setting up to run a curved leg using the plywood template shown. Running a top bearing bit. The grain on the walnut does not look too coarse after trimming the profile out of the blank. My plan is to run them through an oscillating sander to reduce the excess to a minimum and then use double sided tape, both ends and middle, to clean up the edge. I'm hoping the prep on the oscillating sander will help me eliminate any potential tear out. I will use a sacrificial piece on the back side where I need to in order to prevent tear out.
Anything I haven't thought of or where I am off base?
Thanks for your input.
Go Bengals. Sorry I lived in Northern Kentucky years ago and got to see the Rams with Dickerson play the Bengals. I got my Father to come up and took him to the game.
Brian
router set up.jpgrouter mystery pin.jpg