-
I would think if it were the saw, it would be consistently off by a specific amount over a specific distance, no? Like, out by 1/8" over 3'.
-
A) that would be a strange scenario
B) you can just do the math on a calculator real quick to get you close to what you want to see on a fractional tape and verify it w/ the X measurements.
C) As said above, you can also just measure two parallel sides and if they are good AND your X measurement is good, then life is good.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules