I have a Universal 40mW Engraver. It has been working fine until two days ago. I was able to move the laser on the Y axis fine. I went to move it on the X axis and it jumped about 1/2 inch and then stopped. I tried again to move it, but it was locked. I exited Lightburn and shutdown the engraver. I tried this a couple of times. after about the third time, I couldn't get it to move on the Y axis either. I assume this is a controller board problem. If so, I'm looking for a 3 axis board compatible with Lightburn, Grbl, and win 11. Any advice?