Results 1 to 4 of 4

Thread: gravograph ls100 wont boot

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1

    gravograph ls100 wont boot

    hi, iam new in the forum, but i being reading here for a couple years. i have a gravograph ls100 that i bought brand new around 8 years ago. iam far away to be an expert but i always try to read and understand. i stoped working with the ls100 4 years ago, and now i started using it again,. i was working ok ., but suddenly, today i was doin some cuts in a 2mm MDF then when i finished it i went for dinner. when i came back i tried to continue with other jobs but then windows print spooler said L-solution cant complete job. so i tought some windows error so i proceed to power off the Ls100 and then power back on. here came the problem.

    After turning it on, the printer should emit a couple of beeps, and then show on the control panel ready to receive. but it just doesn't beep and nothing is visible on the control panel. therefore I do not have access to the start menu. or to any parameter, it is simply on but does nothing. It is not detected by windows either. any suggestion you can give me?
    Last edited by hector garcia; 11-25-2022 at 4:59 PM.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts