Hi
I have started using a chinese laser. All of my design files are in Corel so I use the RD Works macro to export from Corel to RD Works and then send the file to the laser. Everything works but......
In Corel I often reverse cut my drawing ie I design it then flip it over and then send this to the laser (Universal machine). With the chinese laser it looks like it works:- when I send it from Corel to RD Works, in RD Works the design shows as still flipped but then when I press start the laser cuts it face up ie somewhere between RD Works and the laser the file has became unflipped!!!
I've spent hours hunting for a solution, I'm assuming the problem is in RD Works but I can't find anything that ensues wysiwyg. Can anyone help or is the answer to try Lightburn?
TIA
ps If it's important, the controller is a Ruida 6442S controller. I have a 6445S but haven't had the time to do a changeover.
pps if anyone can tell me why it wont cut at the X and Y position on the page in RD Works? If I set it to Current Position, this works but if I try Anchor Point the machine starts the cut at the far right and in the middle of the bed, it ignores the anchor point in RD Works.