Maple Desktop Organizer

[steven c newman]

Based on the Paul Sellers' plans....with my own "improvements"..
Project Post, end view.JPG
Smaller dovetails..Rosewood plugs to cover the holes left by grooves, to house a 3/16" Maple floor board..
Project Post, front view.JPG
Drawer was made from 3/8" thick stock....made a box with through dovetails, then laminated a Front to that..
Project Post, opened view.JPG
Sellers used 1/2" stock...I had to resaw the Maple, and wound up with 3/8" thick sides. Top is 11/16" thick, base is 1/2".
Stain is Witch's Brew...

There is a build along thread....about a 10 day build.

[Ben Ellenberger]

I like it! Is yours a little taller and less deep than the one Paul Sellers made?

[steven c newman]

Paul Sellers uses 3-1/2" tall sides, I used 4" Tall sides....He used 1/2" thick sides, I went with 3/8". length and width are the same, though...