Enlon 6" x 80" Edge Sander

[Ron Hampe]

I'm not finding any info on them. Are they a decent brand?
The seller said that there is an issue with the tension adjuster and sent this picture, but it doesn't look like anything is broken.

[Aaron Inami]

It could be that all the debris and gunk in the tension spring and rod is causing a problem with movement of the tension mechanism. It could be that the whole tension mechanism needs to be disassembled and cleaned and re-adjusted and then lubricated (after years and years of use). It's hard to say without hands on to see what the problem actually is.

Sorry, no idea on the Enlon brand itself.

[Ed Aumiller]

The Enlon brand came out about the time grizzly started and was apparently made in the same factories as grizzly... early to mid 90's..
I have several enlon tools.. I had a 16" bandsaw and gave it to a friend who broke the table trunnions... looked up a 16" grizzly from the same era and parts fit perfectly...
Had a 6" jointer and grizzly parts fit it also..
If you get it and need any parts, you can probably get them from grizzly...

[Ron Hampe]

Thanks I'll disassemble and clean everything if I get it.

[Ron Hampe]

Thanks.

I actually looked there first to see if they had a similar model and have bought parts from them for some of my other tools.