Had my planer in storage and it got wet. While it is almost trash I am going to try and get it going again. The part that I need is the bracket that holds the shaft in the base that connects the two screw shafts that operate the leveling shafts that raise and lower the table. I could also use the table as this one is really trashed, but the bracket is the most important. Due to the fact that I live (barely) on SS and not doing woodworking professionally any longer I'd really just like to get this fired up if possible. I really only rarely use it, the bracket is #8859 on the base illustration(although the part does not look at all like the drawing). Thanks for looking