Picked one of these up recently on a decent deal, but just needed some rust cleanup on the tables, fence and cutter head. I got the whole thing broken down, then back together without much issue.

However now when I try to set the knives at the recommended height (1/8" above the gib), either with a dial indicator or the Grizzly gauge listed specifically for the model, the knives will catch on the outfield table when properly aligned.

I can get it to work with the knives set a hair under 3/32". Not sure if this is going to cause an issue, but also just a bit of an oddity and wondering if others have ever run into this.