I know we have a few folks doing or re-doing shops right now. I would like to emphasize:
- Take pictures.
- Take them sequentially.
- Name them well.
Knowing what is behind the wall I am about to set anchors into is great.
2nd BS DC Drop (5).jpg2nd BS DC Drop (6).jpg
I had built in this drop for future use. The future is now. I simply removed the cap from the vertical drop, added a 45 degree elbow, 6x6x4 wye, stub of pipe, and a couple of more 45 degree elbows.
2nd BS DC Drop (9).jpg
The shop made blast gate will supply a short piece of 6" hose to a 6x4x4 wye that feeds the upper bandsaw port and an under the table collection point. Sort of like the primary bandsaw shown here in a bit of disarray.
2nd BS DC Drop (10).jpg
The 4" port and gate are for a "temporary service" hose that will connect to tools rolled into that area on demand.
2nd BS DC Drop (11).jpg
The hose coils behind the saw until needed.
Reply With Quote