The title says it all. I have an 18' long piece of cellular PVC trim I need to accurately rip to width. It is way too long for my shop, so ripping on my slider (right of blade) is out of the question. So, two options, as far as I can see.
1) Use the horrible little contractor's table saw I have available. My concern is to due to the length and flexibility of the material, it is unlikely to produce a square, consistent cut and that I'll need several people available.
2) Use my Festool EQ55. I don't own enough track to do this in one shot. Is it feasible to set the track, cut as far a the track reaches, move track and repeat? If I go this route, any warnings or suggestions you can offer to improve my outcome?