Couple of years ago I obtained a used 14" Jet bandsaw. After tuning and pimping it up it has proven to be a excellent 2nd BS and sees limited usage.I noticed when I got it what appeared to be a one inch scratch that on closer examination proved to be a small hairline crack in the table from one side of the blade slot. Barely detectable to the fingernail. Now for some reason that crack has tripled in length on one side and started on the other side of the slot but still remains barely detectable.
It does not affect the performance of the saw but I would like it to not get longer. I always keep the blade slot alignment pin in place. Any suggestions on what to do short of replacing the table?