This is my acquisition for the day:
00b0b_jlHI9C1ZunWz_0t20CI_1200x900.jpg
00606_9tAKNCWgiKKz_0t20CI_1200x900.jpg
00404_dhB98mDMdlpz_0t20CI_1200x900.jpg
00H0H_b0iKfvUIRFxz_0t20CI_1200x900.jpg
01717_8W5WOLwM667z_0CI0t2_1200x900.jpg
00O0O_1ddby1LQkl2z_0t20CI_1200x900.jpg
00M0M_duLUrQQjE9Xz_0CI0t2_1200x900.jpg
A Craftsman 6x48" belt sander. The pulley on the motor is a little tweaked to the motor bounces up and down then the motor is turning. I believe the problem is just the pulley, I think the motor shaft is straight. I will need to craft a table for it. I have some steel plate that should do the job.
$40