Gmorinng everyone
so if youve been followinng along. started putting primer on the doors.
it might be my ocd but i dont think so yet.
noticed here and there that after the first coat of primer dried.
on the plywood beadboard panels, i can see what i think are short grain ends lifting a bit.
im sure it will show thru paint. so before putting on second coat of primer, whats the best way to fix these?
its not all over, just a few of the panels, not all.
the panels had been sanded to 180 grit.
im thinking if i sand them back down lightly and then use the 3m glazing putty, but
not sure. anyone have these experiences?
regards eric