Hi Anibal
Here is a link to a video on calibrating a Hammer A3-31 (which I also own) ….
https://m.youtube.com/watch?v=aEq5C5oovFk
Regards from Perth
Derek
Hi Anibal
Here is a link to a video on calibrating a Hammer A3-31 (which I also own) ….
https://m.youtube.com/watch?v=aEq5C5oovFk
Regards from Perth
Derek
As I also commented on the video when I saw it...that's not much of a calibration instruction, he only checks that his settings are good. The tricky part is when they are not and there you are not helped much by that video.
@Anibal I had the previous version A3-31 before and for that machine there is a very detailed document how to adjust the machine in terms of table parallelism. I assume that's the document you will have pm'd from another member.
Hi Ola
The video is helpful in that it shows you what to do to - the bolts to adjust - when calibrating the A3-31.
Do you have a link you your source?
Regards from Perth
Derek
I think it's this one. "Think" meaning I thought this was for the latest a3-31 and that I didn't have the link for the previous version anymore, but looking at the pics this seems to be for the previous version a3-31. http://maschinen.felder-gruppe.at/up...Guide_A331.pdf
Last edited by Ola Carmonius; 04-29-2022 at 4:32 AM.
To see pictures you must become a contributor which is only six bucks a year. There is a donate button near the top of the page. There are a couple more percs too.
Steve Jenkins, McKinney, TX. 469 742-9694
Always use the word "impossible" with extreme caution